Installed X2.3b/ Probs.

[jmanse]

:bawling: I recently installed a x2.3b pro. I booted the xbox and it tuned off and back on and off again and back on. When it turned itself on and stayed on I get no video and i get a flashing red/green light. I was able to get the cromwell bios scren only one time. Thanks for your help.

[noyfb™]

if you have a 1.5 version xbox with a focus chip, you need to use the standard av lead.

you will then see the cronwell bios screen to flash the bios.

if you turn off the chip does the xbox boot? if yes d0 is ok.

have you got a bios disk? have a look over teamxecuter/ xboxscene.

we will help ya out anyhow, :)

[nimbles]

Well these are what are commonly regarded as what the LED errors represent. From Xbox-scene:
GREEN/RED Flashing:
Probably a bad chip or bad image.

SOLID GREEN/No EJECT/No AUDIO/No VIDEO:
Probably a bad solder point. Check all your points again.
It could also be a heat problem , make sure your fan is connected and don't put your xbox near heat sources. You can also try to open the top of the xbox and check if it goes better.

SOLID GREEN/No AUDIO/No VIDEO:
This is probably a problems with your audio settings. Try to boot your xbox with a standard a/v pack instead of a HD pack.

ORANGE/GREEN Flashing:
No AUDIO/VIDEO (A/V) pack.
This may also be down to a solder splash on the board or a damaged track.

ORANGE Flashing:
This may also be down to a solder splash on the board or a damaged track. May also be due overheating.

GREEN for half a sec then RED Flashing:
Bad/Corrupted or Empty Eeprom.

SOLID RED:
System overheated , hardware failure , ...


Think its probably bad installation- maybe untidy soldering?

[smokafatty]

Yep, sounds like an install problem. Double check that all the wires are in the right spot. Also you may want to use the alt d0 point instead, its much easier.
http://www.x-elixis.com/final/installation/do-point.htm

[jmanse]

With the chip on or off I still have the same problem. I`ll check all my connetions. Thanks everyone